Result — No as the intended direct replacement. IKEA specifies its nominal 33 × 12 inch shelf for the 12-inch-deep IVAR system, while the nominal 33 × 20 inch shelf is a different depth. Equal width does not make their support locations interchangeable.

Dimensions: nominal system names and actual boards
The two US IVAR shelves below share the same listed 32⅝-inch actual width and ¾-inch thickness. Their depths differ substantially. IKEA identifies the shallow shelf as article 303.181.63 and says it fits IVAR storage of 12-inch depth; it is completed with the appropriate IVAR side unit.
| US shelf article | Nominal system size | Actual W × D × thickness | Listed shelf load |
|---|---|---|---|
| 303.181.63 | 33 × 12 in | 32⅝ × 11¾ × ¾ in | 77 lb |
| 803.181.65 | 33 × 20 in | 32⅝ × 19⅝ × ¾ in | 99 lb |
The nominal sizes are selection labels. Use the actual board and the matching system instructions when checking a used unit. Packaging length is another measurement and should not replace the product dimensions.
Check depth at the side-unit supports
Identify the side-unit depth from its label or complete-product instructions. Measure its actual front-to-back support arrangement and compare it with the shelf’s intended mounting points. Measure the shelf itself in both directions so a width and depth label cannot accidentally be swapped.
The actual shelf-depth difference is 19⅝ − 11¾ = 7⅞ inches. This arithmetic does not describe a permissible overhang. It simply shows why the deeper board is not the shallow system’s specified part.
Use the included cylinder pins correctly
IKEA lists cylinder pins as included with the shallow shelf. Inspect the matching shelf, supports and pins as an assembly. Do not assume an improvised bracket, relocated hole or leftover generic pin reproduces the intended support. A board that can rest temporarily on something has not passed the manufacturer’s compatibility check.
For older IVAR parts, compare the actual articles and their matching instructions before combining them. Age, a similar wood finish or a matching width does not establish identical hardware. Obtain the correct replacement parts if the intended pin arrangement is absent or damaged.
Check the complete unit after selecting the right shelf
Follow the full shelving instructions for assembly, bracing and securing. A shelf’s listed load does not replace the requirements for the complete unit or wall attachment. Distribute loads as instructed and use the appropriate stated limit for the exact shelf and configuration.
Measure the room footprint after adding all required structure. A deeper side unit can intrude into a walkway even if the same-width shelf fits between two walls. Check baseboards and the route for inserting the shelf without leaning or twisting an unsecured frame.
For replacement shopping, write the side-unit depth, shelf article and required hardware on one note. This prevents a common purchase error: selecting “33-inch IVAR” by width while overlooking the 12-inch versus 20-inch depth family.
Before you decide
- Identify the IVAR side-unit depth and exact regional shelf article.
- Separate nominal system labels from actual board dimensions.
- Match the intended cylinder pins and mounting positions.
- Follow full-unit bracing, securing and load instructions.
FAQ
Are both shelves 33 inches wide in actual measurement?
The listed actual width is 32⅝ inches; 33 inches is the nominal system label.
Can I let the deeper shelf hang over the shallow frame?
That is not the specified direct fit. Use the matching shelf and side-unit arrangement rather than improvising support.
Official sources and scope
Specifications and guidance checked on 22 October 2026. The named model and region control; follow the matching current instructions for your product. Worked examples are identified as hypothetical.



