Result — Conditional. IKEA US MITTBACK trestle 304.599.97 has a listed 22⅞ × 13¾-inch footprint and a support-height range of 27½–36⅝ inches. These are trestle measurements. The finished table’s footprint, top height and usable chair space depend on the tabletop, orientation and assembly arrangement.

1. Identify the MITTBACK trestle and tabletop
Use the article number and the current assembly drawing for the trestle you actually own. This guide covers the US birch 304.599.97 listing, rather than an older FINNVARD or another similarly shaped support. Record the tabletop article or specification separately. The current instruction drawing identifies named IKEA tops in its attachment sequence; do not treat a tabletop of similar outside size as automatically having the same construction or fixing details.
2. Dimensions: mark the support in its real orientation
IKEA labels the trestle width as 22⅞ inches and depth as 13¾ inches. Keep those manufacturer labels in your notes and rotate the outline to match the installation drawing when placing it beneath the tabletop. The long dimension of the support may run in a different room direction from the tabletop’s long dimension. A paper floor plan is useful here: mark each support, the tabletop perimeter and any nearby wall before deciding that a shallow-looking desk arrangement has enough supporting space.
| Check | Reference / action |
|---|---|
| Check | IKEA US 304.599.97 reference |
| Trestle width | 22⅞ in |
| Trestle depth | 13¾ in |
| Support height | 27½ in minimum; 36⅝ in maximum |
| Finished flat top height | Chosen support setting plus actual top thickness |
| Tilted arrangement | Check both edge heights and the complete projection |
3. Add tabletop thickness to the support height
The specified 27½–36⅝-inch range belongs to the trestle. For a flat permitted assembly, calculate finished top height from the chosen support setting plus the actual tabletop thickness. In a hypothetical example, a 27½-inch support and a 1-inch top produce a 28½-inch upper surface. That arithmetic is not a statement about the thickness of any named IKEA tabletop. Check the underside clearance separately because aprons, reinforcement and attachment hardware can reduce the useful space for knees or a chair.
4. Plan the tilted configuration separately
MITTBACK can support a flat or tilted work surface as described by IKEA. Tilting changes the front and rear heights and the projection of the complete tabletop, so a single nominal desk height no longer describes the arrangement. Sketch the raised rear edge relative to a wall, shelf or window and check the intended fastening procedure. Consider how your work materials will be retained using the approved arrangement. Do not improvise a larger tilt by removing stops or altering support hardware.
5. Check chair movement, access and stability
Place the intended chair between the supports and check the actual sitting position, knee room and path used to get in and out. The lower trestle shelves and legs occupy space that a simple drawing of the tabletop can miss. Include nearby drawers or doors that need to open while the desk is in place. Assemble and secure the combination as instructed, then follow IKEA’s guidance about re-tightening screws after approximately two weeks and when needed. Repeat the clearance check if you change the top or support settings.
Before you decide
- Match the trestle and tabletop identities.
- Draw the actual orientation of both supports.
- Add top thickness and inspect underside knee space.
- Check tilt geometry, chair access and specified assembly.
FAQ
Is 27½ inches the finished table height?
It is the trestle’s minimum listed height. The upper surface also depends on the tabletop and assembly.
Can I judge chair clearance from the tabletop size?
No. Check the supports, lower shelves, underside fittings and the chair’s entry path.
Official sources and scope
Checked on 23 October 2026. These references apply to the identified product, version and region. Follow its matching current instructions. Any worked measurement example is hypothetical.



