Result — Conditional. Umbra’s Estique 5 Over the Door Hook fits doors up to 1½ inches thick, but door thickness and the gap above the door are different checks. Confirm both with the actual bracket and check the loaded door’s movement.

Dimensions: measure the leaf, then the head gap
Umbra lists this Estique model at 15.2 × 4 × 12 inches, also shown as 39 × 10 × 30 cm, and specifies doors up to 1.5 inches / 3.8 cm thick. The product page rates each hook for up to 5 lb / 2.3 kg. These figures describe the named five-hook over-door product, not every Estique organiser.
| Measurement or rating | How to use it |
|---|---|
| Door-leaf thickness | Up to 1½ in / 3.8 cm for the cited model |
| Overall organiser size | 15.2 × 4 × 12 in; check its projection and width |
| Per-hook capacity | 5 lb / 2.3 kg; check the door and complete arrangement too |
| Gap above the door | Measure the actual bracket and the available closed-door gap |
| Loaded movement | Check latch, frame, adjacent wall and hanging items |
A door that is too thick gives a clear no
For a hypothetical 1¾-inch-thick door, the difference from the published 1½-inch limit is ¼ inch. That door exceeds the stated fit. Do not stretch or bend the bracket to bridge the difference; you would no longer be checking the product in its intended configuration.
Measure the solid door leaf at the top edge rather than the frame opening or a decorative moulding elsewhere. Check both bracket positions if the leaf has unusual construction. Record the exact organiser model and any protective components supplied with it, because those are part of the installed arrangement.
The door can pass thickness and fail closing
A bracket must also pass through the available gap above the leaf when the door closes. Umbra’s page does not state a universal minimum head gap. Measure the complete actual bracket where it crosses the top, including its supplied protection, and compare with the narrowest relevant closed-door gap. Do not invent a clearance from a photograph.
Start with the organiser empty and follow its assembly instructions. Close the door slowly while watching for contact. Stop if the bracket rubs the frame, changes normal closing effort or prevents the latch engaging. A door that closes only when pushed harder has not passed the check.
Inspect the loaded swing, not only the metal bracket
Hang the intended items within the per-hook rating, then inspect where the bags, straps or coats travel. Check for contact with a nearby wall, another door, furniture and the floor. A strap can extend much farther than the organiser’s published projection and can become trapped at the closing edge.
Confirm the door’s construction, hinges and finish are suitable for the complete load and the supplied contact arrangement. Multiplying the hook rating by five does not establish a door’s capacity. Distribute items as directed and recheck normal latch operation after loading.
Keep a short record of door thickness, measured head gap, organiser model and the items used in the check. This is more useful than a note saying only “fits a standard door,” because a replacement door or a different load can change the result.
Before you decide
- Identify the five-hook Estique over-door model.
- Measure the door leaf and compare it with the 1½-inch limit.
- Check actual bracket thickness against the closed-door head gap.
- Confirm normal latching and a clear swing with the intended load.
FAQ
Is the 1½-inch limit the gap needed above the door?
No. It describes door thickness. The head gap must independently clear the actual installed bracket.
Do five 5 lb hooks mean my door is approved for 25 lb?
No. The organiser’s per-hook rating does not establish the door, hinges or complete arrangement’s capacity.
Official sources and scope
Specifications and guidance checked on 22 October 2026. The named model and region control; follow the matching current instructions for your product. Worked examples are identified as hypothetical.



