Fit verdict: Vitamix E310 fit under a cabinet depends on both assembled height and the space needed to remove the container. Vitamix Australia lists the E310 at 18 inches high, 8 inches wide and 11 inches deep with a 48-ounce, 1.4-litre container. This guide uses those physical dimensions; check the exact regional model and its electrical requirements separately.

Dimensions and conditions
| Check | Reference | Planning consequence |
|---|---|---|
| Assembled height | 18 in | Compare the lowest obstruction, then check container movement. |
| Body footprint | 8 × 11 in | Verify orientation and support the base on the counter. |
| Listed container | 48 oz / 1.4 L | Different containers need model-specific compatibility checks. |
Start Vitamix E310 fit with the lowest cabinet point
Measure from the finished counter surface to the underside of the lowest rail, light fitting or other obstruction. A cabinet opening that looks uniform may have a projecting front trim. Write down the minimum clearance at the intended appliance position and along the route used to pull it forward. Confirm the model label and container against the regional specifications. A height from a different blender or a different container arrangement is not a dependable substitute for this measurement.
Separate stored height from container-removal space
The assembled blender can clear a cabinet while leaving too little room to lift off its container. Check the removal motion with an empty, unplugged appliance and follow the manual for handling the container and blade assembly. Keep fingers away from blades. Include the hand position you need to lift securely, not just the top of the lid. If access requires a different working position, confirm that the empty appliance can be moved and supported there before deciding that the storage location is practical.
Plan filling, lid access and pouring
Think through a complete preparation sequence: put ingredients in the container, fit the lid as instructed, operate in a suitable position, then lift and pour. Do not assume that a small gap above the lid is usable for every action. A nearby cabinet handle or shelf can interrupt the pouring route. Use the actual container and an empty vessel for a dry placement trial. Operating instructions govern lid use and any tamper; this room-planning check does not replace them.
Keep the base supported and the cord free
Measure the full usable counter area rather than allowing the base to bridge an edge, sink opening or unstable board. Check the cord route to a suitable outlet using the regional instructions, leaving it clear of drawers and the container path. Do not treat a different country’s voltage information as applicable to your unit. If you want a lower container to solve a height problem, verify that exact accessory with Vitamix instead of assuming every container that looks similar is compatible.
Vitamix E310 fit: a worked fit example
A hypothetical cabinet opening is 18½ inches above the counter. Against an 18-inch assembled blender, that leaves only half an inch. Suppose a trial of your particular setup shows that removing the container needs two inches of additional upward movement. The stored appliance clears, but that removal action does not. The two-inch movement here is an illustrative measurement, not a published E310 requirement. Test your own unit and the full lifting path; do not convert a nominal half-inch remainder into a guarantee of usable access.
Before you decide: 5 checks
- Confirm E310, regional model details and the supplied container.
- Measure the lowest cabinet feature at the planned position.
- Check container removal with the unit empty and unplugged.
- Rehearse filling and pouring without nearby obstructions.
- Verify stable support, cord routing and accessory compatibility.
FAQ
Does Vitamix E310 fit under any 18-inch opening?
No. An exactly nominal opening offers no allowance for measurement variation, and container movement needs separate assessment.
Can a shorter container solve the problem?
Possibly, but use only an accessory confirmed compatible with your exact unit and follow its instructions.
Are these Australian electrical specifications?
The guide uses physical dimensions from the Australian owner resource. Check electrical requirements for your own regional unit separately.
Related fit guides
- Open-lid clearance under kitchen cabinets
- Counter appliance access and airflow
- More Rooms fit guides
Sources
Sources checked 4 November 2026. Specifications apply to the named version and market. Example spaces and calculations are illustrative planning guidance, not manufacturer clearance requirements. Recheck the exact model or current operator policy before buying, installing or travelling.



