Fit verdict: Fellow Aiden can fit under an upper cabinet when both its closed body and its working access fit. Fellow lists 12 inches closed and 18.5 inches with the top lid open. A cabinet gap that clears the stored brewer may still block normal use.
This guide uses Fellow’s current Aiden external-dimensions support page. It does not establish a minimum heat or steam clearance; follow the appliance instructions and cabinet requirements as well as checking physical movement.

Dimensions and conditions
| Check | Official reference | What to verify |
|---|---|---|
| Length | 8.94 in / 227 mm | Check the actual counter location and connector route. |
| Width | 8.94 in / 227 mm | Body footprint, before neighboring objects. |
| Closed height | 12 in / 305 mm | A storage fit only. |
| Top lid open | 18.5 in / 470 mm | Measure to the lowest cabinet obstruction. |
| Below-spout clearance | 16 cm | Compare the actual mug height and insertion path. |
1. Measure Fellow Aiden to the cabinet’s lowest point
Use the counter surface supporting the brewer as the vertical starting point. Measure to the lowest trim, light fitting or cabinet projection directly above the lid, not just the main cabinet panel. Compare the closed height and the 18.5-inch open-lid height separately. A measurement exactly on the published boundary leaves unresolved manufacturing and measurement variation. Verify the actual unit instead of assuming that a barely touching lid is a practical operating fit.
2. Plan a fully supported working position
If the stored position does not allow lid access, assess another permitted location on the counter before buying. The complete base must remain supported, with the power lead routed correctly and the appliance used according to its instructions. Do not operate it partly over an edge just to clear the cabinet. Mark the intended working footprint and check that it does not block the sink, cooking area or the path used to set down hot vessels.
3. Include the water tank, basket and cup movement
Fellow describes the water tank and showerhead as removable for hand washing. That makes service access part of the space plan, not an afterthought. Check how the tank and basket are handled in the current user instructions, then allow the necessary movement. For single-cup use, compare your actual mug with the stated 16-centimeter below-spout clearance and its insertion path. A mug’s capacity in ounces does not establish its height or handle clearance.
Before you decide: 5 checks
- Measure from the supporting counter to the lowest obstruction.
- Compare 12-inch closed and 18.5-inch open-lid heights.
- Check a fully supported permitted working position.
- Allow tank, basket and cleaning access.
- Measure the intended mug and verify its insertion and removal route.
Keep a short Fellow Aiden fit record with the exact product or service identity, the official rule you checked and the measurements from your own setup. Mark anything you could not verify as unresolved. Recheck the record if the product, accessories, route or surrounding space changes; an earlier fit result belongs to the configuration that was actually checked.
FAQ
Will Fellow Aiden work under a 16-inch cabinet gap?
That clears the listed closed height but not the listed 18.5-inch open-lid height. Another permitted working position would need assessment.
Is 18.5 inches a steam-clearance requirement?
It is the published height with the top lid open, not a stated minimum heat or steam margin.
Can I judge a mug by its capacity?
No. Compare its actual outside height, handle and movement with the spout area.
Related fit guides
Continue with KitchenAid Tilt-Head Fit: 5 Upper-Cabinet Checks or browse Rooms fit guides. Check each item against its own specifications; a related guide does not establish this product’s compatibility.
Official sources
Sources checked 27 October 2026. Measurements and conditions are attributed above; room and packing checks are planning guidance. Recheck the current official instructions before purchase, installation or travel.



