Quick answer: A 5/6 in label is a housing category, not proof that a retrofit module fits every can with a similar opening. Check the exact module’s compatible housings, depth, attachment system and electrical requirements.

Identify the housing and retrofit together
Read the existing housing label and obtain the selected retrofit’s instructions before removing or changing parts. Distinguish a retrofit module for an existing can from a canless light requiring its own ceiling opening and driver arrangement.
As an identified example, HALO’s RL56 SeleCCTable product page describes use with compatible 5 and 6 in housings. Its linked specification sheet PS518012EN, dated February 26, 2023, shows a 7.25 in (184.2 mm) trim diameter and different profile heights for different lumen versions. That historical drawing is not a dimension for every newer RL56 variant.
Compare the hidden depth, not just the trim
The visible ring can cover the ceiling opening while the driver or module conflicts with the can interior. Check the drawing for the purchased catalogue number, its required housing dimensions and the allowed attachment method. Existing socket brackets and other parts can change the available space; do not remove them unless the exact instructions allow it.
| Reference | Why it differs |
|---|---|
| Nominal 5/6 in housing category | Identifies intended family, not complete compatibility |
| Trim outside diameter | Determines visible coverage, not hidden depth |
| Module/driver envelope | Must fit the permitted housing interior |
| Clips or torsion springs | Must engage the compatible support arrangement |
In a hypothetical same-axis check, 80 mm of required module space cannot fit within 70 mm of unobstructed depth: the shortfall is 10 mm. Those are illustrative numbers, not RL56 dimensions or a complete assessment of a housing.
Keep installation approval separate from appearance
Check the housing/material conditions, voltage, dimmer and any location or insulation rating in the exact documentation. A ring sitting flush does not establish electrical, thermal or listing compatibility. Use a qualified electrician where the housing is unidentified or the instructions do not clearly match.
Do not cut the module, bend retention parts beyond their instructions or crowd wiring into an unapproved space. A new fixture that visually covers the old hole still needs an approved, supportable installation.
Before you decide
- Existing housing label and exact retrofit catalogue number identified.
- Current model-specific compatibility instructions obtained.
- Interior depth, driver, wiring and retention envelope checked.
- Electrical, location and thermal conditions verified by the installer.
Common questions
Does a 7.25 in trim fit a 7.25 in ceiling hole? The trim is a cover dimension; use the specified housing or cutout requirements for the exact product.
Can I use any RL56 drawing? No. Variants and revisions differ; match the purchased catalogue number.
Official sources and scope
Checked October 21, 2026: HALO RL56 SeleCCTable product family, HALO PS518012EN model-specific 2023 specification. Confirm the exact product, route or current policy before acting. No firsthand fit test is claimed.
Related guide: Ceiling Fan Clearance: 5 Useful Room-Fit Checks. This addresses a separate fit check; its measurements do not transfer to the products above.



