2026 Toyota RAV4 Garage Fit: Height, Mirrors and Roof Gear

Quick answer: Use trim-specific heights for the 2026 Toyota RAV4, then measure the exact car with its roof gear fitted. Woodland is listed at 69.1 inches with roof rails and a crossbar. Toyota’s 73–74-inch “overall width” table does not establish a verified mirror-to-mirror entry width; measure mirrors open and folded before judging a tight garage opening.

Checked October 4, 2026 · US specifications · Documentation and measurement guide; no hands-on fit test.

2026 Toyota RAV4 Woodland 69.1-inch crossbar height reference, with complete roof equipment and the lowest garage obstruction to measure.
The known Woodland crossbar height is only a reference. Measure the complete installed setup and the lowest point of the route.

2026 Toyota RAV4 height by trim and powertrain

The US sixth-generation RAV4 needs its own dimensions check. Page 4 of Toyota’s 2026 RAV4 Sales Consultant Guide separates Hybrid and Plug-in Hybrid heights. Keep those columns separate rather than treating every RAV4 as one height.

Powertrain / gradeToyota’s height descriptionInchesCalculated mm
Hybrid, other gradesWith antenna66.71,694
Hybrid WoodlandWith antenna67.11,704
Hybrid WoodlandWith roof rails and crossbar69.11,755
Plug-in Hybrid SE / XSEOverall height66.91,699
Plug-in Hybrid GR SPORTOverall height66.31,684

“Other grades” follows Toyota’s Hybrid-table wording. The guide does not provide a separate Plug-in Hybrid Woodland height in that column; do not transfer a Hybrid number to an unlisted configuration as a guarantee. Metric figures above are calculated from inches and rounded to the nearest millimeter.

Why the published width cannot settle mirror clearance

Grade groupingOverall lengthPublished overall width
Other grades181.0 in (4,597 mm)73.0 in (1,854 mm)
Woodland182.0 in (4,623 mm)74.0 in (1,880 mm)
GR SPORT182.9 in (4,646 mm)74.0 in (1,880 mm)

These values come from the same Toyota exterior table. It does not label a mirror-open or mirror-folded span. This guide therefore does not treat either width as the full entry envelope and does not invent an estimate for the mirrors.

Ask a dealer to measure the exact vehicle across its widest mirror points, first open and then in the folded position supported by the vehicle. Record the configuration and the units. Do not infer power folding from the presence of power mirror adjustment.

Length still needs its own check: measure from the front obstruction to the inside limit of the closed garage door. Account for any fitted item that projects beyond the published vehicle. Extra length cannot be assumed to provide liftgate room unless it is actually behind the parked vehicle.

The Woodland roof-box trap

A hypothetical garage route with a true 84-inch minimum height exceeds the published 69.1-inch Hybrid Woodland crossbar height by 14.9 inches (378 mm). That subtraction does not show that a cargo box fits. It is simply the remaining height above the stated crossbar configuration before further equipment.

A roof box’s catalog height is not necessarily the amount it adds above the bar. The mounting arrangement, base shape and exact equipment matter. Measure from the ground to the highest point of the complete installed setup on level ground. Do not use a guessed stock-roof-plus-box sum to clear an uncertain doorway.

For an illustrative measured setup that is 82.0 inches tall, an 84.0-inch route leaves 2.0 inches by static subtraction. If a lower obstruction makes the route 81.5 inches high, the same setup exceeds it by 0.5 inches. The example is hypothetical, not a recommended gap or a claim about any box model.

Make a roof-configuration measurement card

Keep one record for each configuration you actually use. A measurement made before a trip’s roof equipment was fitted is no longer a complete garage check.

Configuration cardRecord
Exact model year, grade and powertrain2026 / ___ / Hybrid or Plug-in Hybrid
Installed crossbars, box or other gear___
Measured ground-to-highest-point height___ in
Lowest clear height along the full route___ in
Static difference: route minus setup___ in
Mirror-open / folded measured width___ / ___ in
Date and configuration photo___

Measure the route with the garage door fully raised. Check its bottom edge, tracks, brackets, opener and any stored overhead object that the car or gear could pass beneath. Also inspect changes of slope; a level-ground vehicle height does not model every point on an inclined approach.

Keep hands and measuring equipment away from a moving garage door. Resolve uncertain clearance while the vehicle is stationary outside the obstruction. If you cannot verify the roof setup, remove the roof load in a clear location or use another verified parking place before attempting entry.

Keep a dated photograph with the roof-configuration card. Show the exact crossbars, carrier and any load you intend to take through the garage. Mark where you measured the vehicle’s highest point and identify the lowest obstruction along the route. That makes it easier to repeat the comparison after equipment is moved or replaced.

Record mirror clearance on a separate line. Toyota’s published overall width is not a substitute for the missing mirror span, and the roof-height check cannot settle doorway width. If an exact measurement is unavailable, label the result unknown and ask the seller to help measure the car in the intended configuration. Repeat the route check after a roof-box change, a different mounting position or a change to garage storage. Keep the Hybrid and Plug-in Hybrid identification on the same card so the height reference remains tied to the correct vehicle.

Check the hatch and daily use separately

Closed height does not provide the fully open liftgate height or its swept path. A car that parks below a ceiling can still need more room to load groceries or remove equipment. Check those movements against the exact vehicle instructions and known-clear surroundings.

For a purchasing decision, take the measurement card to the dealer and fill the missing mirror and installed-equipment fields. The unanswered fields are the point: Toyota’s trim table is useful, but it cannot supply the dimensions of your complete setup.

The practical answer to “Will a 2026 RAV4 fit my garage?” is conditional on the trim, powertrain, roof configuration and actual route. If any one of those remains unknown, pause the tight-clearance verdict rather than borrowing a number from another generation or market.